Latest News & Trends

Error Codes Of Samsung Top Load Washing Machine | How to Rectify Them

Sometimes Samsung top load washer showing DE error code. this is often not an enormous issue. Samsung top load washer comes with safety features like door lock system, which is beneficial for child safety. But thanks to some reasons this function not working and shows DE error code.

So during this article, I’m explaining to you ways to unravel this problem. Follow the below steps and you'll get your washer working back!

Step #1

Open the rear cover. Check any carbon on the connector of the door switch, if there's any carbon particles then clean it. to wash the carbon particles properly use a toothbrush and IP liquid.

Now please check the washer by restarting it. could also be your problem is being solved.

If still showing DE Error Code then follow subsequent step.

Step #2

Check the door hinges and observe carefully for any damage to hinges. Change the door if hinges are broken. Also, check the switch hinges and observe carefully for any damage to hinges. Change the switch if hinges Broken

Now after changing the actual part, please check the washer by restarting it. could also be your problem is solved.

If still showing DE Error Code then follow subsequent step.

Step #3

Check the door switch continuity by employing a multimeter, must show continuity if the door is closed. change the door switch if continuity not showing.

After changing the Door Switch, please check the washer by restarting it. could also be your problem is solved.

If still showing DE Error Code then follow subsequent step.

Step #4

Open the front panel. Check the wiring continuity between the door switch connector and therefore the PCB connector. If continuity not showing, then change the wiring with connector otherwise you also can change the whole wire harness.

After changing the wiring or entire wire harness, please check the washer by restarting it. could also be your problem is solved.

If still showing DE Error Code then follow subsequent step.

Step #5

If the above four testings found ok, then got to repair or replace PCB with the new one. Now your problem solved definitely!

Please note that sometime your washer problem are going to be solved in any of the one-step or a while it'll need two or more steps also.

If you continue to have doubts inquire from me within the comment. Also, share your feedback or suggestions within the comment box.

You may also read my Blog for better understanding.

Comments (0)


leave your comment


Top