Latest News & Trends


d01 No water flows in. Open tap and press the "lnicio“ button again. This malfunction could also be caused by an improper water system hose connection
d02 Pump filter blocked. Clean the pump filter and re-start the program with the “Inicio” button. Check drain hose: The connection must not be blocked
d03 Drain hose condition: The connection must not be blocked
d06 Drum blocked. Check if alittle laundry item (e.g. handkerchief, sock...) possesses between the detergent dispenser and drum. For access to rock bottom of the dispenser
d07 Lid improperly closed. Check if the lid is closed. Start the programme using the ”lnicio“ button.

Bosch WA SERIES washer error codes

YES The washer door is unlocked. it's possible to feature laundry.
NO Due to the heat within the drum, the washer door can't be opened. Wait until the temperature drops.
  Due to the high level of water within the drum, the washer door can- not be opened. Drain the water (e.g. select the Spin or Empty programme (if only a drain cycle is required, set rpm (spin speed) to Rinse hold = 0 without final spin selected).
E:16 Laundry may become trapped. Close the washer door properly.
E:17 Turn on the cold water faucet fully
E:29 Supply hose kinked or trapped
  Water pressure too low. Clean the filter in ?
A: 10 Turn on the recent water faucet fully, supply hose kinked or trapped.
  Supply hose kinked/trapped; water pressure too low. Clean the filter.
  Hot water hose not connected; washer is operated using cold water only. Ignore the message; this message is merely showed for the primary wash cycle.
E:18 Detergent solution pump blocked. Clean the detergent solution pump.
  Drain hose/waste pipe blocked. Clean the drain hose on the siphon.
E:23 Water within the base trough thanks to appliance leaking. Call after-sales service.
CL If childproof lock is active, inactivate it.
Other displays Switch off the appliance, await five seconds and switch it back on again. If the

Comments (0)

leave your comment